This table summarizes high one-hour and eight-hour ozone averages in the metropolitan areas where the DAQ monitors ozone.
Please Note: Data in this table is based on the number of monitors operating in an area, as well as on the severity of ozone.
This data should not be used to perform comparisons between cities or across years without factoring in the number of monitors.
The peak one-hour and eight-hour averages are color-highlighted based on the EPA-defined Air Quality Index colors. (See Interpreting the AQI.)
|Metropolitan Area||One-Hour Averages|
>= 125 ppb
>= 71 ppb
|Peak Value||High Days||Peak Value||High Days|
|Greater Las Vegas||No averages at or above 125||No averages at or above 71|
|Jean||No averages at or above 125||No averages at or above 71|
|Boulder City||No averages at or above 125||No averages at or above 71|
|Ozone averages are reported in parts per billion (ppb).|
|The High Days columns represent the number of days where one-hour or eight-hour ozone averages were at or above the thresholds of 125 ppb and 71 ppb respectively.|
The information in the table is composed of ozone measurements from monitoring sites across Clark County. There are two averaging periods that are of interest for ozone: a one-hour average and an eight-hour average. There are national air quality standards that have been established by the EPA for both of these averaging periods.
For the one-hour ozone average, a threshold of 125 ppb has been used to determine high value days. For the eight-hour ozone average, a threshold of 71 ppb has been used. Only averages that are equal to or higher than one of these thresholds appear in this table. The High Days column is a count of the number of days each metropolitan area experienced high ozone measurements (either one-hour or eight-hour) for the selected year. Out of all the averages at or above the thresholds, the peak or highest one-hour and eight-hour averages and the date they occurred are shown.
Ozone formation tends to be highest from March through October. Before May, there will be few if any metropolitan areas with high ozone readings. Some metropolitan areas never experience high ozone. In either of these cases, the table will show "No averages at or above 125", or "No averages at or above 71".
Each NAAQS pollutant has a separate AQI scale, with an AQI rating of 100 corresponding to the concentration of the Federal Standard for that pollutant. Additional information about the AQI and how it can be used is available from the EPA's AirNow web site.
Place your mouse pointer over the scale displayed above to view information about the Air Quality Index, and each of the rating levels.
The actual index calculation is different for each parameter measured and is specified by the EPA. The following table shows the various breakpoints used in calculating the AQI.
|AQI Breakpoint Definitions|
|AQI Range||1hr Ozone
|0 - 50||Not Defined||0 - 0.054|
|51 - 100||Not Defined||0.055 - 0.070|
|101 - 150||0.125 - 0.164||0.071 - 0.085|
|151 - 200||0.165 - 0.204||0.086 - 0.105|
|201 - 300||0.205 - 0.404||0.106 - 0.200|
|301 - 400||0.405 - 0.504||0.201 - 0.2011|
|401 - 500||0.505 - 0.604||Not Defined|
|500+||Not Defined||Not Defined|
PLEASE NOTE: This data has not been verified by the Clark County Department of Air Quality and may change. This is the most current data, but it is not official until it has been certified by our technical staff. Data is collected from Clark County Department of Air Quality ambient monitoring sites and may include data collected by other outside agencies. This data is updated hourly. All times shown are in local standard time unless otherwise indicated.